Steeda Q Competition

Washer Nozzle Locations
Cowl-Induction Cooling























Fully Finished Show Quality Underside
2" Cowl Height
Latch Plates Tested to 300 lbs. without failure
Super Strong Aircraft Grade 6061-T6 Aluminum Latch Plate


Super Strong Aircraft Grade 6061-T6 Aluminum hinge plates

Most companies use rear-screened vents for cooling. At Boss, we found that rear-screened vents weaken the structure, don't flow much air, and can be ugly to look at while driving. The Steeda Q hood uses a revolutionary design that moves the rear framework away from the rear weather seal. The seal keeps out the rain, while the air space created allows up to 10X the airflow of a rear-screened vent. This superior design maintains structural strength and provides a smooth rear surface to look at while driving.

The Steeda Q Competition hood has been race tested and proven to keep your inlet temp within 10 degrees of the ambient air.

A denser air charge = MORE POWER.











Precision fit. Each Steeda hood starts from an original factory Ford hood. (No copies here!) We painstakingly produce each class "A" mold in-house to exacting tolerances in order to consistently achieve a precise fit.

"Pessimistic bodyman was very impressed". We use only the highest quality resins and materials available in the industry to produce our hoods. This level of materials allows our highly trained technicians to consistently produce hoods with a smooth, wave-free surface that is virtually ready to paint. In fact, prep-time on a Steeda Q hood is typically less than one hour (vs. 4-6 hrs min. for our competitors). At a typical body shop rate of $50/hr, this will literally save you several hundred dollars off your overall bodyshop bill.

Amazingly light, yet incredibly strong. Weight savings = performance gain. Most of our competitors '05-'09 hoods weigh 38-45 lbs. The Steeda Q Competition hood weighs in at only 29 lbs. (Same as the stock Aluminum hood). How, you ask? Strength through design (instead of mass). This proprietary technology yields a hood that is a min of 9 lbs. lighter than any other fully-finished hood available anywhere, yet strong enough to withstand the rigors of brutal all-out racing. This hood is featured on Steeda's flagship Q650R.


At idle, heat escapes the engine bay through the rear cowl area. Starting at approximately 5mph, the cowl-induction system kicks in and creates cooling effect that seriously cools the engine. A great solution for the intense heat of turbo or blower applications.













The Steeda Competition Hood flows 438% more airflow than the Steeda street version.

The aggressive profile of the Steeda Q Competition hood allows for maximum clearance under its 2" rise. The fully functioning Cowl Induction will keep your intake temp within 5 degrees of ambient. Whether you're running a stock 3.8, a blown 4.6, or an all out racecar setup, this hood has you covered.





















Copyright 2016 Boss, Inc.  All rights reserved.